Section 8 – Configuration
QUESTION 1
In what Cisco solution is Simple Network-Enabled Auto Provision technology used?
A. Cisco Unified Gateway Duplication
B. Cisco UnifiedCallManager Redundancy
C. Cisco Unified SRST
D. Cisco Unified Call Survivability
Answer: C
Explanation:
Ok, check 1-57 and 2-87: Fallback for IP Phones
The Cisco Unified SRST gateway uses Simple Network-Enabled Auto Provision (SNAP) technology to autoconfigure the branch office router to provide call processing for Cisco IP phones that are registered with the router
QUESTION 2
Where do you specify the device mobility group and physical location after they have been configured?
A. phones
B. DMI
C. device mobility CSS
D. device pool
E. MRGL
F. locale
Answer: D
Explanation:
Ok, check 4-32, step 3: Configure Device Pools
QUEION 3
Which two locations are the best locations that an end user can use to determine if an IP phone is working in SRST mode? (Choose two)
A. Cisco Unified Communications Manager Administration
B. IP phone display
C. Cisco Unified SRST Router
D. Cisco Unified MGCP Fallback Router
E. physical IP phone settings
Answer: BE
Explanation:
Ok, end-user reference
QUESTION 4
Which statement best describes globalized call routing in Cisco Unified Communications Manager?
A. All incoming calling numbers on the phones are displayed as an E 164 with the + prefix.
B. Call routing is based on numbers represented as an E.164 with the + prefix format.
C. All called numbers sent out to the PSTN are in E-164 with the + prefix format.
D. The CSS of all phones contain partitions assigned to route patterns that are in global format.
E. All phone directory numbers are configured as an E.164 with the + prefix.
Answer: B
Explanation:
Ok, 1-65 CIPT2 v8.0
QUESTION 5
While configuring Call Survivability in Cisco Unified Communications Manager, what step is mandatory to reach remote sites while in SRST mode?
A. Enable Cisco Remote SiteReachability.
B. Configure CFUR.
C. Enable the SRST checkbox in the MGCP gateway.
D. Configure the H 323 gateway for SRST in Cisco Unified Communications Manager.
E. Enable the Failover Service parameter.
Answer: B
Explanation:
Ok, 2-25 CIPT2 V8.0
The CFUR feature has to be configured on the Cisco Unified Communications Manager to reach remote sites in SRST mode.